Awesome. I'll bet you can't wait. Will you have it out to the track this year?

Sweet!

Nice Douglas.

Like Vince, will you have it ready and race at all this season?
I'd love to see it back in action.

Well it was running and ran great all that i excepted except for alum showing up in oil at heads, back apart it came. Found main one and two oil ports plugged up with steel and cast iron chips, I paid for cleaning for assy and even looked over block my self were the stuff was hidding is beyond me but it collected into the oil galley and bounced around beween mains and crank oil galley eating away at the bearings. rear main and #4 were never hurt. Put about 1 hour running time on motor and
then started tearing it apart. Dam it never trust anyone with with your motor for any dam thing. Long hours at work afew hours at a time al my bad i guess. No real damage polish crank new bearing a good cleaning job by me and back together again. NEVER TO CLEAN basics #1 and i fucked up. But everything else was just TITS. Turnings came from line boring job steel mains and cast iron block material same guy was paid to wash block for assy. All the plugs were pulled out there was some dam corner it was hidding. My bad.

Could have been a lot worse.

Been wondering where you been hiding.
Keep us posted!

all clean and getting ready, trying for Odgen Ave Rt 66 show this week end looks like a long nites. shit ill fire it up at the show if i have to ear plugs contact roooooooaaaaaaaaaarrrrrrrrrr voooooooommmmmm.

sweet...let us know how it goes!!!!

so far so good nothing in oil 45 mins run time to 200 degrees. looking good.

well i have a car and engine that wants to go but after 40 years the radiator finally took a shit lol i come to fine out were i got it from slipped my mine for years 3007719 Harrasion rad. from a 1966 biscane 427 425hp 4 speed car lol a oldie but rare goodie time for a recore. To the track soon .

Can hardly wait to hear about your outing!!!!

Keep us posted star! I wanna hear how that monster does!!

ME TOO

Good luck, Star! Hope it kics a$$! WC1

Well i did get it out wed and got to make only one pass my porting got me into trouble got to thin in #6 cylinder exh port and it finally burn thur and pissed water into cylinder during the run and foulded out plug i put in a 6500 rev chip so my big foot wouldnt over rev it for afew break in runs but i made a nice pass on seven 10.70 at 128 mph easy enough to braze up and fix its apart and head is ready to braze. Hopefully ill get it back out again soon and pull the 6500 chip out. Steel mains and bottom end seems fine except for water in oil. AHHHHHHH back at it lol. And thats the reason i bought a sonic tester about a 1/16 x 1/8 hole burn thur http://s5.photobucket.com/albums/y171/s ... 010007.mp4

http://s5.photobucket.com/albums/y171/s ... 010009.mp4


http://s5.photobucket.com/albums/y171/s ... 010008.mp4